Bradford White M-I-100T6SX 100 Gallon 88,000 BTU Residential Atmospheric Vent High Input Energy Saver Gas Water Heater (LP Gas)
M-I-100T6SX Bradford White 100 Gallon 88,000 BTU Residential Atmospheric Vent High Input Energy Saver Gas Water Heater (LP Gas)
Heater is a propane gas (LP) model and features a titanium stainless steel propane burner
- Bradford White ICON System - Intelligent gas control with proven millivolt powered technology and built-in piezo igniter. A standard, off the shelf thermopile converts heat energy from the pilot flame into electrical energy tooperate the gas valve and microprocessor. No need for external electricity.
- Enhanced Performance - Proprietary algorithms provide enhanced First Hour Delivery ratings and tighter temperature differentials.
- Advanced Temperature Control System - Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels.
- Intelligent Diagnostics - An exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting.
- Pilot On Indication - Flashing green LED provides positive indication that pilot is on.
- Separate Immersed Thermowell - High strength advanced polymer composite thermowell provides isolation between electric temperature sensor and surrounding water. No need to drain the tank when removing gas valve.
- Factory Installed Hydrojet 2 Total Performance System - Cold water inlet sediment reducing device helps prevent sediment build up in tank and increases first hour delivery of hot water.
- Vitraglas« Lining - Bradford White tanks are lined with a exclusively engineered enamel formula that provides superior protection from the highly corrosive effects of hot water. This formula (Vitraglas«) is fused to the steel surface by firing at a temperature of over 1600ºF.
- Side Connections - 3/4" NPT tappings that allow easy connections for space heating applications (potable water only).
- Non-CFC Foam Insulation - Covers the sides and top of tank, reducing the amount of heat loss. This results in less energy consumption, improved operation efficiencies and jacket rigidity (M-I-75 has 1-1/4" and M-I-100T has 2").
- Pedestal Base.
- Water Connections - Factory installed true dielectric fittings extend water heater life and eases installation.
- Hand Hole Cleanout - Allows inspection of tank interior and facilitates the removal of sediment deposits (M-I-100T models only).
- Protective Magnesium Anode Rod.
- 4" "Snap Lock" Draft Diverter.
- T&P Relief Valve - Included.
- Low Restriction Brass Drain Valve - Durable tamper proof design.