Ships within 2 - 3 days from our warehouse.
UPC: 775937000118Finish: White
The SANIPACK is a unique product which allows you to install a wall hung toilet. It provides connections for both a sink and shower for an easy bathroom installation. The reservoir, macerating pump and pipes are hidden inside the wall. This type of installation can give you the clean look of a European bathroom. The SANIPACK can be installed in many locations such as a loft/attic, upper floor, ground floor, basement, and even a garage. This system is used to install a bathroom up to 9 feet below the sewer line, or even up to 100 feet away from a soil stack. It can handle the effluent from a toilet, sink and shower.
The unit pumps the effluent upward 9 feet and/or 100 feet horizontally (with gravity fall). A normal operating cycle for SANIPACK takes about 7-9 seconds. In addition to the toilet waste, the SANIPACK will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a shower and a urinal. When adding a shower, a base will have to be constructed. This base should be made out of a 2” X 6” or 2” X 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4” per foot gravity flow towards the pump unit.
The wastewater from other sanitary fixtures is discharged into the SANIPACK via two 1 1/2 inch inlets on either side of the housing. Either one or both inlets can be used as required. The discharge elbow on top of the SANIPACK can be turned either to the left, to the right, or towards the back, depending on the discharge installation. A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit.
This unit has been designed with a vent connection on the lid. All plumbing codes require connection to a vent system. The vent system should be a two-way air vent. The use of mechanical vents, air admittance valves, or similar devices are not permitted as these are considered one-way air vent systems.